![]() ![]() Print the project and check the result.Select the printer, filament, and process you would like to use for the test.It is suggested to turn on the bed mesh leveling for this test. However, its accuracy highly depends on your first layer quality. The line method is quick and straightforward to test. NOTE: For Bambulab X1/X1C users, make sure you do not select the 'Flow calibration' option when printings. ![]() Make sure to select the appropriate version for your test. It is important to note that each method has two versions: one for a direct drive extruder and one for a Bowden extruder. Each method has its own advantages and disadvantages. Orca Slicer includes three approaches for calibrating the pressure advance value. ** Remember ** to save the filament profile. In this case, if your previous flow ratio was 1.029 and you selected the block with a flow rate modifier of -6, the new value should be calculated as follows: 1.029x(100-6)/100 = 0.96726. ![]() The flow rate modifiers for this project will range from -9 to 0. This process is similar to Pass 1, but a new project with ten blocks will be generated. ![]() ** Remember** to save the filament profile. If your previous flow ratio was 0.98 and you selected the block with a flow rate modifier of +5, the new value should be calculated as follows: 0.98x(100+5)/100 = 1.029. Update the flow ratio in the filament settings using the following equation: FlowRatio_old*(100 + modifier)/100. Slice and print the project.Įxamine the blocks and determine which one has the smoothest top surface. Select the printer, filament, and process you would like to use for the test.Ī new project consisting of nine blocks will be created, each with a different flow rate modifier. Flow rate NOTE: For Bambulab X1/X1C users, make sure you do not select the 'Flow calibration' option.Ĭalibrating the flow rate involves a two-step process. NOTE: After completing the calibration process, remember to create a new project in order to exit the calibration mode. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |